A modified bitumen membrane (MBS) roof is a system developed by taking the qualities of a BUR system along with the qualities
of a single-ply roof. A standard MBS roof system should have a base sheet or ply, similar to the BUR system, then a waterproofing
sheet similar to single-ply.
To break it down, a modified bitumen membrane is composed primarily of polymer-modified bitumen reinforced with one or
more plies of fabric such as polyester, fiberglass, or a combination of both. Factory surfacing, if applied, includes mineral
granules, slag, aluminum, or copper.
Modified bitumen's generally use a traditional waterproofing medium -- asphalt -- modified with atactic polypropylene
(APP), styrene butadiene styrene (SBS), synthetic rubber, or other agents that will enhance the asphalt properties. APP and
SBS are the most common bitumen modifiers.
The most common modified bitumen's are:
- SBS (Styrene-Butadiene-Styrene) modifies the asphalt by forming a polymer network within the bitumen.
SBS gives the bitumen rubber-like characteristics and improved resistance to aging and weathering. Most SBS modified bitumen
sheets are either set in hot mopping asphalt, torch-applied, or adhered with cold-process adhesives. SBS modified bitumen
sheets that do not have factory applied granule or foil surfacing need some form of field-applied ultraviolet protective coating.
- APP (Atactic Polypropylene) is a thermoplastic polymer, which forms a uniform matrix within the asphalt.
This enhances the bitumen's performance by increasing its UV resistance, increasing its flexibility at low temperatures, and
improving its flow resistance at high temperatures. APP modified bitumen sheets are generally applied using a propane-fueled
torch. Applicators use the heat to soften the modified bitumen on the underside of the sheet. The sheet's bottom surface becomes
a molten adhesive, which flows upon the substrate and then cools to form a waterproof adhesive bond. Some APP sheets can also
be applied with cold-process adhesives.
Base sheet/shingling of felts
MBS are not considered a built up roof but considered a single-ply. Still it is encouraged to install a base sheet/underlayment.
Similar to the built up roof systems, a contractor should apply one of the following:
- Standard glass-fiber felt (2-ply fiberglass platform (minimum) or a 3-ply base)
- Coated glass-fiber felt
- Coated organic felt
This is to protect the roof system from any water penetration and protect the insulation from the heat of the torch. After
the plies have been installed then the MBS roof system can be installed. For the reasons mentioned above we have classified
the MBS roof system as a built up roof.
- Mineral granules
- Metallic foil
- Asphalt (hot or cold applied)
- Heat-reflective coatings